Review of MB102 Solderless Breadboard 830 Tie Points 2 buses, bread power supply and jumper cables.

Review of MB102 Solderless Breadboard 830 Tie Points 2 buses, bread power supply and jumper cables.


Introduction

A solderless prototype breadboard allows the development of circuits for testing of designs as well as development of software for Arduino, ESP32, ESP8266 development boards and sensors.


MB102 Power Supply

This device can plug into the power rails of the breadboard and can supply 5Volts and 3V3 with an 2.1mm power jack with an  input voltage: 6.5-12 V (DC) or USB power supply at 700mA.

MB102 Breadboard

The breadboard has 830 tie points with two power supply rails.

 Breadboard Jumper cables

Consisting of 65PCS:
49 pcs 120mm length*2
8 pcs 150mm length*2
4 pcs 200mm length*2
4 pcs 240mm length*2


Where to buy


Conclusion

The quality of the breadboard is very good i recommend getting this set. Ideal for beginners and hobbyists.

Comments

Post a Comment

Popular

Installing CH340/ CH341 drivers for Arduino, ESP32 and ESP8266 boards

Image
Installing CH340 / CH341 drivers for Arduino, ESP32 and ESP8266 boards. Introduction With the development of Arduino, ESP32 and ESP8266 boards there has been a requirement to communicate to these devices via USB. There are several of these components or Integrated Circuits (IC) available that are installed on development boards. In order to communicate to these boards with Arduino IDE or other IDEs there is a requirement to install specific drivers. Procedures Close Arduino IDE Mac Download and install drivers from here After installing the drivers the computer is required to be restarted for the drivers to function. To confirm drivers are working correctly connect device goto terminal type ls -l /dev/tty.* the device will be displayed in the list as shown in the Figure 1 Figure 1 - list of devices Caution OSX Sierra (10.12) users It has been reported the driver WILL crash on OSX Sierra. Make sure to use this one instead: ch340 v1.3 driver For fur...
Read more

Setup for using ESP32 development boards

Image
Setup for using ESP32 development boards Installing the ESP32 Core Mac Open Terminal and execute the following command (copy->paste and hit enter): mkdir -p ~ /Documents/Arduino/hardware/espressif && \ cd ~ /Documents/Arduino/hardware/espressif && \ git clone https://github.com/espressif/arduino-esp32.git esp32 Once complete then with following copy->paste into terminal and hit enter cd esp32 && \ git submodule update --init --recursive && \ cd tools && \ python get.py If you get the error below. Install the command line dev tools with xcode-select --install and try the command above again: xcrun: error: invalid active developer path (/Library/Developer/CommandLineTools), missing xcrun at: /Library/Developer/CommandLineTools/usr/bin/xcrun xcode-select --install Restart Arduino IDE Windows Download and install the latest Arduino IDE  Windows Installer  from  arduino.cc Dow...
Read more